build Embedded system 3d metal detector -- 3

Hello sir/ma, I'm interested in taking this task up for you. I am an Electrical Engineer with a masters degree and I have high proficiency knowledge in: FPGA firmware in VHDL and Verilog for Altera/Actel/Xilinx FPGAs and EEG signal, MCU firmware in C/C++ for ARM, TI, NXP, Atmel, PIC, Arduino; Bluetooth, Raspberry Pi, OpenCV, Deep Learning, Bluetooth Low Energy (BLE), and wireless modules programming,, GPS modules, Temperature, Pressure sensors, Metal Detectors, motor drivers, 12V, 24V DC motors, Schematic, PCB Layout: Altium Designer, Component selection, BOM generation, Gerber generation, HVAC, LTE system model, Thermal system design, Matlab/ Simulink, Microcontroller, Modeling, optimization, simulation of building energy systems, and have been working on Industrial Automatics, Prototyping, PCB Design, Development of Electronic systems. Once you share the project, I will have a look & confirm if I can do it. I’m honest, creative and a unique person to carry out your tasks given to me. Leaving your project on our hand is privileged; we'll make sure that the project is done in a perfect way and do our best until you were satisfied. I would love to discuss this project with you and meet your exact requirements. I am confident I can provide you with top-notch materials that will fit your needs. I pride my work on being professional, of the highest quality and always delivered on time.

HI I am experienced in Software Architecture Electrical Engineering Embedded Software etc I can start right now but i have few doubts and questions lets have a quick chat and get it started waiting for your reply

Hi, I'm Leandro and I'm a design and digital animation student. I specialize in software like Cinema 4D, Maya, and After Effects. I would like to know a little more about the project, and offer you a proof of my quality,