Power supply design.

Hello, I am an electronics and telecommunication engineer and my major is wireless systems' design. I am experienced in hardware and embedded systems' design. I have designed/printed/tested many PCBs and I am quite experienced with RF design such as designing antennas, matching networks(distributed/lumped elements), filters(distributed/lumped elements), power amplifiers, dividers, feed networks, differential pairs/signals, EMI, clearance areas, shielding for EMI, conducted interference, common mode, etc, LVD, high speed data communication. I also designed a couple of smps and I have checked your requirements I am quite sure that I can help you with your project. Just give me all the details and I will do my best to help you. Best regards

hello sir, how are you. I read your proposal and i am interested in this project. I have much experience on circuit design and development. Let us discuss more. . I am an Embedded engineer (STM32, PIC, AVR, Arduino, SOC BLE (bluetooth) chips, ZigBee, WiFi, GPS, LED, LCD display etc.) and PCB designer), 3D Modeling. You can check my profile for more information. thanks with regards Preetpal Singh

Hi dear , i have read your project description, i can design the PCB board for power supply , microcontroller based , will use PIC18 or arduino controller ,which will have conrolling and will be perfact. Thanks

Hi, going through your requirements I've already selected the appropriate design for your work,and I will be using the half bridge topology as it can deliver the power based on your requirements,I will also implement current control where you can adjust using a pot also I will provide you with circuit, firmware and transformer winding calculations so that you can modify it in the future if you like. I have more than 10 years experience building switching power supplies and have designed battery chargers,buck converter,boost converter,solar mppt controllers. I am available in the chat section for further discussions. Thank you.

Hi I have more than 8 years experienced in circuit design and development in my past I have designed lot power supply for company I can design best way without emimec

Hello my brother. I am an electrical and electronic engineer. I can help you with this in a maximum period of 6 days and with high quality.