Toy Control Module

Control board needs to be able to drive the 2 main LED lights and a secondary led, play audio files based on movement, light the secondary LEDs when the device detects an impact, basic on/off switch, and connect to a small 2w speaker. Fixed wiring for all components except for the switch and the lighting – these need connections so that they may be connected/disconnected during construction and maintenance of the toy. Features & Maximum Ratings: Dimensions: 53x23.5x7.5 mm (with the microSD card). - Power supply: 5.5 to 11 V / 3.5A (with the High-power LED). 2 li-ion cells (18650 or 14500) batteries recommended. - Idle current consumption : 10 mA (deep sleep mode) - Speaker: 4 to 8 ohm. - Audio output Power : 2W - Accent LEDs : 8 - Accent LEDs pad current source : 18 mA max per pad - On-board, sizable PLI - Trident™ (cross-guard) support - Blade mirroring accent LEDs - Handles momentary or latching for blade activation - Up to 12 selectable sound banks via audio menu - Blaster Blocking, Force, Force Clash™ and Lockup Fx - StabFx™, SpinFx™ & ComboFx™ - Blade Flickering & Core pulse Fx - Blade Shimmering on Clash - Blaster Sounds - Up to 4 boot sounds - Up to 16 swing and 16 clash sounds - Flash on Clash™ (FoC™) - Anti Power On / Off technology (A-POP™) - Blaster Move™ - Power on Force™ - Hilt Angle Ignition Sound Selection - Mute-on-The-Boot™ - Alternate Power Off sounds (motion vs no motion) - Configurable Idle mode & power saving timer - Wake-up on motion with WakeOnMove™ - Motion-triggered Ignition - 32 stage accent LED sequencer - Crystal Chamber specials - WAV file support - True 16 bit, 22.050 k Samples/sec crystal clear DAC - iSaber Audio Player, up to 99 WAV tracks, play/pause/shuffle - SD card support: up to 16GB, FAT16 or FAT32. - FlexiBlend™ powered Color Mixing on 4 channels using the satellite board - Configurable normal blade, FoC & Lockup colors Housing: The control board, battery (Panasonic PAN1850P), and speaker need to be housed in a 22mm wide cylinder that is between 130mm and 150mm in length. Example: [login to view URL] Lighting: The LEDs need to be mounted on a flat copper disc (20mm wide x 2mm deep) with the wires routed through a center hole and a disconnect between the LEDs and the cylinder/control board. This needs to be wired with a plug at the end to allow the lighting and wiring to be disconnected from the control board/device. LED Example: [login to view URL] I will need all design files for this concept at completion of this project.